Complete workshop & service manual with electrical wiring diagrams for 1985-2011 Honda TRX250, TRX250EX, TRX250 TE, TRX250 TM, TRX250X, TRX300EX ATV. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Honda TRX250 1985-2011 ATV service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

├── '01-'05\ TRX250EX\ Sportrax.pdf
├── '05-'11\ TRX250\ TE_TM\ Recon.pdf
├── '06-'11\ TRX250X,\ TRX250EX.pdf
├── '85-'87\ TRX250\ Fourtrax250.pdf
├── '86-'89\ TRX250R\ FOURTRAX\ 250R.pdf
├── '87\ TRX250X\ Fourtrax.pdf
├── '87-'06\ TRX(250X)(300EX).pdf
├── '97-'04\ TRX250TE_TM\ FourTrax\ Recon.pdf

EXCERPT:

CYLINDER HEAD/CYLINDER/PISTON
CYLINDER HEAD INSTALLATION
ROCKER ARM HOLDER ASSEMBLY
('97 - 2001)
Lubricate the rocker arm and rocker arm shaft with molybdenum disulfide oil.
Place the rocker arms into the rocker arm holder, then insert the rocker arm shaft.
NOTE:
If reusing the rocker arms, install them into their original locations as marked.
Turn the rocker arm shaft using a screwdriver to align the hole between the rocker arm holder and shaft.
Apply oil to the thread and flange surface of the rocker arm holder bolt.
Install and tighten the bolt to the specified torque.
CYLINDER HEAD INSTALLATION
Install the dowel pins and a new cylinder head gasket as shown.
Install the cylinder head.
NOTE:
Do not install the gasket upside down. Install it as shown.
Properly install the push rods into the center groove of the cam follower.
NOTE:
If reusing the push rods, install them into their original locations as marked.
'97 2001: Install the two dowel pins.
'97- 2001: Turn the crankshaft with the recoil starter and align the 'T' mark on the flywheel with the index mark on the rear crankcase cover.
Make sure the piston is at TDC of the compression stroke. If not, turn the crankshaft one full turn and realign the "T" mark with the index mark.
…