Complete workshop & service manual with electrical wiring diagrams for Honda V45/V65 1982-1988 Motorcycle. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Honda V45/65 Sabre & Magna (VF700, 750 & 1100 V-Fours) service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

Models covered:
Honda V45 700/750 Sabre. US 1982 through 1985
Honda VF750S-C Sport. UK 1982 through 1984
Honda V45 700/750Magna. US 1982 through 1988
Honda VF750C-H and C-J Custom. UK 1987 through 1988
Honda V65 1100 Sabre. US 1984 through 1985
Honda V65 1100 Magna. US 1983 through 1986

EXCERPT:
1982 and 1983 750 Sabre models
Right handlebar removal
3 Disconnect the wire from the front brake light switch.
4 Remove the screws from the right handlebar switch assembly and separate the upper and lower sections. Disconnect the throttle cables from the throttle grip; back off the adjuster or free them at the carburetors first to create enough cable slack.
5 Remove the two brake master cylinder mounting bolts and lift it off. Tie the assembly out of the way so that the master cylinder is not tipped or hanging upside down.
6 The right handlebar can now be removed by first loosening the handlebar pinch bolt and removing the snap-ring from the fork tube. Once it is disconnected from the fork leg, the throttle grip and right switch assembly can be slid off its end.
Right handlebar installation
7 Spread a light coat of grease over the handlebar end for the throttle to slide on. Slide the throttle grip and switch assembly onto the bars.
8 Install the right handlebar over the fork tube and position it correctly. Install the snap-ring and then tighten the pinch bolt to the specified torque.
9 Install the front brake master cylinder, noting the UP marking on its clamp. Fully tighten the upper bolt first, then the lower.
10 Connect the throttle cables to the throttle grip, then join the switch halves and tighten the screws securely; tighten those at the front first.
11 Reconnect the front brake switch wires and secure all wiring and hoses with new ties. Install the rear view mirror.
12 Check the throttle cable free-play if the cables were disturbed (see Chapter 1).
Left handlebar removal
13 Disconnect the wires from the clutch switch.
14 Remove its screws and separate the two halves of the left handlebar switch. On later models, leave the choke cable outer connected to the switch lower half, but disconnect the inner cable from the choke lever.
15 Remove the two clutch master cylinder mounting bolts and lift off the master cylinder, noting that the master cylinder clamp will remain attached to the choke cable on early models. Tie the assembly out of the way so that the master cylinder is not tipped or hanging upside down.
16 On early models, there is no need to disconnect the choke cable outer from the clutch master cylinder clamp, just disconnect the inner cable from choke lever.
…