Complete workshop & service manual with electrical wiring diagrams for New Holland T9000 Series (T9010, T9020, T9030, T9040, T9050, T9060) Tractors. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This New Holland T9010, T9020, T9030, T9040, T9050, T9060 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

“Repair manual.pdf”
New Holland T9000 Series (T9010/T9020/T9030/T9040/T9050/T9060) Tractors Repair Manual
2,378 pages

NOTE: Engine repair information is not contained within this tractor Repair Manual. For engine repair, refer to appropriate engine repair manual as follows:
87515682 - For 8.3 & 9.0L 6 Cylinder, 24 Valve CNH Engine with High Pressure Common Rail Fuel System. 87523643 - For 12.9L 6 Cylinder, Engine.
…

— — — — — — — — — — — — — — — — — — — — — — — —

“87562838.pdf”
New Holland T9010/T9020/T9030/T9040/T9050/T9060 Tractors Operator’s Manual
87562838 8/06 Replaces 87399833
284 pages

— — — — — — — — — — — — — — — — — — — — — — — —

“87517740.pdf”
T9010, 9020, 9030, 9040, 9050, 9060 Series Tractors For Powershift Transmissions Euro Electrical Schematic

— — — — — — — — — — — — — — — — — — — — — — — —

“87522497.pdf”
NAO Tj 280, 330, 380, 430, 480 And 530 Series Tractors & Euro T9010, 20, 30, 40, 50 And 60 Series Tractors Hydraulic Schematics Equipped With Megaflow Rac. 87522497

EXCERPT:
Section 21 - Transmissions, Drivelines - Chapter 1
TRANSMISSION REMOVAL
STEP 1
Refer to Cab Removal and Installation in this manual and remove the hood.
STEP 2
To drain the transmission, slowly loosen the split flange bolts on the lubrication pump suction tube.
Control the flow by tightening or loosening the bolts.
NOTE: The transmission fluid capacity is approximately 38 to 45 litres (10 to 12 gallons).
When the transmission is completely drained. Remove the split flange bolts and the retainers.
STEP 3
Remove the fill tube from the transmission.
STEP 4
Remove the four nuts and two bolts to remove the rear axle driveshaft cover.
STEP 5
Remove the rear axle intermediate driveshaft from the transmission output yoke. Move the driveshaft rearward away from the transmission.
STEP 6
If equipped, remove the driveshaft from the PTO MK99J255 Remove the front frame wire harness connector from clutch output yoke.
…