Complete workshop & service manual with electrical wiring diagrams for Mitsubishi 3000GT 1991-1999. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Mitsubishi 3000GT 1991-1999 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

MAKE: Mitsubishi
YEAR: 1991 1992 1993 1994 1995 1996 1997 1998 1999
MODEL: 3000GT, 3000GT Spyder (a.k.a. Mitsubishi GTO, Dodge Stealth)

EXCERPT:
REMOVAL & INSTALLATION
FUEL PRESSURE RELEASE
1. To relieve fuel pressure, remove fuel pump cover in luggage compartment. Disconnect fuel pump harness connector at fuel tank. Start engine. After engine stalls, turn ignition switch to OFF position. Disconnect negative battery terminal. Reconnect fuel pump harness.
2. Wrap shop towels around fuel return and high pressure hoses to prevent fuel splashing on engine.
Disconnect fuel return hose and high pressure fuel hose to drain any residual fuel.
ENGINE
Removal (Eclipse & Galant)
1. Remove hood. Release fuel system pressure. See FUEL PRESSURE RELEASE. Drain cooling system.
Remove air cleaner assembly. Remove heater and radiator hoses. Remove radiator. Remove front exhaust pipe.
2. Label and disconnect all vacuum hoses. Label and unplug all electrical connections and harnesses from engine. Remove starter, oil pressure switch and generator connectors. Cover fuel hose with shop towel, and disconnect high pressure fuel hose. Disconnect fuel return hose. Remove accessory drive belts.
Remove A/C compressor from compressor bracket with hose attached.
3. Remove power steering oil pump from engine with hose attached. Remove engine mount bracket and engine mount stopper. Ensure all hoses and wires are disconnected, and set aside. Attach engine hoist to engine. Remove engine from engine compartment.
Installation (Eclipse & Galant)
To install, reverse removal procedure. Tighten bolts and nuts to specification. See TORQUE SPECIFICATIONS.
…