Complete workshop manual contains service, maintenance, electrical wiring diagrams, and troubleshooting information for the 2012-2016 Nissan NV (F80 Series) (NV1500, NV1500 S, NV1500 SV, NV2500, NNV2500 HD S, NV2500 HD SV, V3500, V3500 HD S, V3500 HD SL, V3500 HD SV). Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for 2012-2016 Nissan NV (F80 Series) (NV1500, NV1500 S, NV1500 SV, NV2500, NNV2500 HD S, NV2500 HD SV, V3500, V3500 HD S, V3500 HD SL, V3500 HD SV)is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
ELECTRICAL & POWER CONTROL
REMOVAL AND INSTALLATION
POWER SOCKET
Removal and Installation
FRONT POWER SOCKET, CONSOLE POWER SOCKET AND 3RD ROW POWER SOCKET
NOTE: If unable to use the tool because of power socket location or access to the harness connector, then further removal of interior components may be required. Refer to IP-14, "Exploded View" (Front Power Socket) to remove cluster lid C lower finisher, IP-25, "Removal and Installation" (Console Power Socket, if equipped) to remove the front center console or IP-26, "Exploded View" (Third Row Power Socket, if equipped) to remove the rear lower finisher (LH).
Removal
1. Remove the fuse for the power socket.
2. Insert one side of the Tool (A) into one of the square holes inside the power socket.
3. Lift up the handle of the Tool until the other side snaps into the other square hole in the power socket.
4. Pull the power socket straight out with the Tool.
5. Disconnect the harness connector from the power socket.
6. Remove the ring from the power socket finisher while pressing the pawls.
Installation
Installation is in the reverse order of removal.
NOTE: Make sure to align the tab with the square notched area during installation.
...

Nissan NV 2012-2016 Workshop Repair & Service Manual