Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2006-2014 Subaru B9 Tribeca, Tribeca, Tribeca Limited, Tribeca Premium, Tribeca Touring. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for 2006-2014 Subaru B9 Tribeca, Tribeca, Tribeca Limited, Tribeca Premium, Tribeca Touring is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
AT Main Case - AUTOMATIC TRANSMISSION
34.AT Main Case
A: REMOVAL
1) Remove the transmission assembly from vehicle body.
2) Pull out the torque converter assembly.
3) Remove the transmission harness connector from stay.
4) Disconnect the air breather hose.
5) Remove the oil charge pipe.
6) Remove the ATF filter inlet and outlet pipes.
7) Remove the extension case.
8) Remove the center differential carrier.
9) Remove the reduction driven gear.
10) Separate the converter case from the transmission case.
11) Remove the control valve body.
12) Remove the oil pump cover.
NOTE: The input clutch pack assembly and front sun gear assembly are also removed together.
13) Remove the needle bearing of the middle carrier assembly.
14) Remove the middle carrier assembly.
15) Remove the rear carrier assembly.
16) Remove the middle & rear sun gear assembly.
17) Remove the thrust needle bearing of high & low reverse clutch.
18) Remove the high & low reverse clutch assembly.
19) Remove the direct clutch assembly.
20) Remove the snap ring of reverse brake.
21) Remove the retaining plate.
22) Remove the leaf spring.
23) Take out the drive plate, driven plate and dish plate.
24) Remove the snap ring of the reverse brake spring retainer.
25) Remove the spring retainer.
26) Remove the return spring.
27) Apply compressed air.
28) Remove the reverse brake piston.
B: INSTALLATION
1) Install the reverse brake piston.
2) Install the return spring.
...