Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Acura Legend 1986-1995. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Acura Legend 1986-1995 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
Control Unit Input Test (KN model).
Disconnect the 8-P connector from the control unit.
Inspect the connector and socket terminals to be sure they are all making good contact.
• If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, make the following input tests at the connector.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, the control unit must be faulty; replace it.
NOTE:
If the shift lock solenoid clicks when you step on the brake pedal with the ignition switch ON (II) (with the shift lever in 0 ), the shift lock system is electronically OK. If the shift lever cannot be shifted from 0, test the shift lever position switch as described on page 23-168 in the 1991 Legend Shop Manual, 62SPOOO, and see section 14 of the same Shop Manual.
...
Interlock System
Component location Index (KN Model)
CAUTION:
• All SRS wiring harnesses are covered with yellow outer insulation.
•Before disconnecting any part of the SRS wire harness, install the short connectors (see page 23-54 of 1993 Legend Shop Manual Supplement 62SP021).
• Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.
...
General Information
Special Tools
Specifications
Maintenance
Engine:
Engine Tune-up
Timing Belt
Cylinder Heads
Engine Removal/Installation
Intake Manifold/Exhaust
Cooling
Engine Block
Engine Lubrication
Fuel and Emissions:
PGM-FI System
Control Systems
Transaxle:
Clutch
Manual Transmission
Automatic Transmission
Driveshafts
Power Steering
Suspension
Brakes
Body
Heater and Air Conditioning:
Heater
Air Conditioning
Electrical
Radiator Cap Testing
Coolant Level Inspection
Engine Oil Level Inspection
Engine Oil Replacement
Air Cleaner Inspection/ Replacement
Compression Pressure Inspection
Spark Plug Inspection
Alternator Belt Adjustment
P/S Pump Belt Adjustment
A/C Compressor Belt Adjustment
Idle Speed Inspection/ Adjustment
Tailpipe Emissions Inspection
Ignition Timing Inspection and Setting
Special Tools
Index
Troubleshooting:
General
Noise and Vibration
Fluid Leaks
Maintenance:
Pump Belt Adjustment
Fluid Replacement
On-Car Checks:
Rack Guide Adjustment
Pump Pressure Check
Steering Wheel Rotation Play
Assist Check
Speed Sensor Replacement
Column
Steering Wheel
Steering Lock
Pump:
Index / Inspection
Replacement
Preload Inspection
Pulley Replacement
Control Valve Inspection and Replacement
Housing Disassembly
Housing Reassembly
Gearbox:
Index / Inspection
Valve Body Unit Disassembly
Valve Body Unit Assembly
Removal
Overhaul
Installation
Ball Joint Boot Installation