Logo

Cart

Click title to display cart contents.
0 Items $0.00

Kawasaki Ninja 250R 2008 Workshop Repair & Service Manual

Catalog: 

Make: 

Model: 

US Dollar: $19.00

Complete factory shop manual including electrical wiring diagrams for 2008 Kawasaki Ninja 250R Motorcycle It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page to save your precious time.

This repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

MAKE: Kawasaki
YEAR: 2008
MODEL: GPX250R, Ninja 250R (EX250J8F, EX250K8F)

"EX250J8F.pdf"
428 pages

"EX250K8F.pdf"
525 pages

EXCERPT:
Quick Reference Guide
General Information 1
Periodic Maintenance 2
Fuel System 3
Cooling System 4
Engine Top End 5
Clutch 6
Engine Lubrication System 7
Engine Removal/Installation 8
Crankshaft/Transmission 9
Wheels/Tires 10
Final Drive 11
Brakes 12
Suspension 13
Steering 14
Frame 15
Electrical System 16
Appendix 17
...
2-30 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Drive Chain Slack Adjustment •Remove the cotter pin [A], and loosen the axle nut [B]. •Loosen the both chain adjuster locknuts [C].
If the chain is too loose, turn in the left and right chain adjuster nuts [D] evenly.
If the chain is too tight, turn out the left and right chain adjuster nuts evenly, and kick the wheel forward.
•Turn both chain adjuster nuts evenly until the drive chain has the correct amount of slack. To keep the chain and wheel properly aligned, the notch [E] on the left wheel alignment indicator [F] should align with the same swing-arm mark or position [G] that the right indicator notch aligns with.
WARNING
Misalignment of the wheel will result in abnormal wear and may result in an unsafe riding condition.
•Tighten both chain adjuster locknuts securely. •Tighten the axle nut.
Torque - Rear Axle Nut: 98 N·m (10.0 kgf·m, 72 ft·lb)
•Turn the wheel,measure the chain slack again at the tightest position, and readjust if necessary.
•Insert a new cotter pin [A].
NOTE
○When inserting the cotter pin, if the slots in the nut do not align with the cotter pin hole in the axle, tighten the nut clockwise [B] up to next alignment.
○It should be within 30°.
○Loosen once and tighten again when the slot goes past the nearest hole.
•Bend the cotter pin [A] over the nut [B].
WARNING
If the rear axle nut is not securely tightened or the cotter pin is not installed, an unsafe riding condition may result.
...

Additional 10% off on US$30+ order paid with Credit Card: 10POFF.

To pay in your local currency (EURO, GBP, AUD, CAD, HKD, JPY, etc.), please contact us.