Complete workshop & service manual with electrical wiring diagrams for Yamaha CS50/Z 2002 . It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Yamaha CS50/Z 2002 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

“EAS00001 (5RW1-AE1).pdf”
Yamaha CS50/Z 2002 Service Manual; 204 pages

EXCERPT:
INSPECTION AND REPAIR
AUTOLUBE OIL PUMP
Internal wear or poor operation may cause the pump to deviate from its factory adjustment.
However, this is very uncommon. If incorrect operation is suspected, inspect the following:
1. Inspect:
• supply line Obstruction Apply air under pressure.
Wear/Damage Replace.
2. Inspect:
• drive gear teeth of the autolube oil pump
• gear teeth driven by autolube oil pump
Pitting/Wear/Damage Replace
CHECKING THE CRANKSHAFT
1. Measure:
• crankshaft runout C
Out of specification Replace the crankshaft, bearing or both.
NOTE:
Turn the crankshaft slowly.
2. Measure:
• big end side clearance D
Out of specification Replace the big end bearing, crankshaft pin, or connecting rod.
3. Measure:
• crankshaft width A
Out of specification Replace the crankshaft. Maximum crankshaft runout
0.03 mm
Big end side clearance
0.2 ~ 0.5 mm
Crankshaft width
37.90 ~ 37.95 mm
…