Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2000-2003 BMW C1, C1-200 Scooter. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your bike like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for 2000-2003 BMW C1, C1-200 Scooter is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT (2000-2003 BMW C1, C1-200 Scooter Service/Repair Manual):
Contents
Group / Chapter
00 Tightening torques operating fluids
00 Pre-delivery check
00 Maintenance
11 Engine
12 Engine electrics
13 Fuel preparation and control
16 Fuel tank and lines
17 Radiator
18 Exhaust system
21 Clutch
24 Gearbox
31 Front forks
32 Steering
Group / Chapter
33 Rear wheel drive
34 Brakes
36 Wheels and tires
46 Frame
51 Equipment
52 Seat
61 General electrical equipment
62 Instruments
63 Lights
65 Optional extras
72 Seat belts

Replace grooved ball bearing and needle bearing for secondary inside plate
Use support ring, BMW No. 36 6 610, and extractor, BMW No. 00 8 570, to remove needle bearing (4)
Remove circlip (3)
Use drift punch (arrow) to drive out grooved ball bearing (2)
Use tube, BMW No. 11 7 645, to press out needle bearing
Press out ball bearing

Grease one side of a thrust washer for intermediate shaft and attach it to side of large gear!
Install seal plug with copper seal
Oil stub of intermediate shaft and install
Position variator shaft in cover
Position output shaft in grooved ball bearing
Mount second thrust washer on intermediate shaft
Install seal
...