Complete workshop & service manual with electrical wiring diagrams for Suzuki GSX-R1000 2001-2009. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Suzuki GSX-R1000 Motorcycle service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

“GSX-R1000(K1-K2) '01-'02 (EN).pdf”
Suzuki GSX-R1000 2001-2002 Service Manual; 444 pages

“GSX-R1000(K1) '01 (DE).pdf”
Suzuki GSX-R1000 2001 Wartungsanleitung; 394 pages

“GSX-R1000(K1) '01 (EN).pdf”
Suzuki GSX-R1000 2001 Service Manual; 424 pages

“GSX-R1000(K3) '03 (EN).pdf”
Suzuki GSX-R1000 2003 Service Manual; 460 pages

“GSX-R1000(K3) '03 (IT).pdf”
Suzuki GSX-R1000 2003 Manuale Di Servizio; 460 pages

“GSX-R1000(K3) '03.pdf”
Suzuki GSX-R1000 2003 Service Manual; 293 pages

“GSX-R1000(K5) '05 (EN).pdf”
Suzuki GSX-R1000 2005 Service Manual; 524 pages

“GSX-R1000(K7) '07 (EN).pdf”
Suzuki GSX-R1000 2007 Service Manual; 549 pages

“GSX-R1000(K9) '09 (EN).pdf”
Suzuki GSX-R1000 2009 Service Manual; 641 pages

EXCERPT:
Cushion Lever Removal and Installation
Removal
1) Remove the right side cowling and side frame covers. Refer to “Exterior Parts Removal and Installation” in Section 9D (Page 9D-6).
2) Support the motorcycle with a jack to relieve load on the cushion levers.
3) Remove the left muffler and muffler chamber heat guard No. 2. Refer to “Muffler / Muffler Chamber / Exhaust Pipe Removal and Installation” in Section 1K (Page 1K-11).
4) Remove the rear shock absorber. Refer to “Rear Shock Absorber Removal and Installation” (Page 2C-3).
5) Remove the cushion levers (1).
Installation
Install the cushion levers in the reverse order of removal. Pay attention to the following point:
• Set the cushion levers so that the arrow mark “A” points forward.
• Install the washers (1) between the cushion rod and cushion levers.
• Tighten each nut to the specified torque.
Tightening torque
Cushion lever mounting nut (a): 98 N·m (9.8 kgf- m, 71.0 lbf-ft)
Cushion rod rear mounting nut (b): 98 N·m (9.8 kgf-m, 71.0 lbf-ft)
…