Complete workshop & service manual with electrical wiring diagrams for New Holland TD60D, TD70D, TD80D, TD90D, TD95D Model Tractors. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This New Holland TD60D, TD70D, TD80D, TD90D, TD95D Model Tractors service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

“603.54.471.00.pdf”
New Holland TD60D - TD70D - TD80D - TD90D - TD95D Model Tractors Service Manual
608 pages PDF
Part number 603.54.471.00− 11 − 2004

"87592264- - TD60D, TD70D, TD80D, TD90D, TD95D Operator's Manual.pdf"
…

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

EXCERPT:

34 SECTION 35 − HYDRAULIC SYSTEM − CHAPTER 1

ADJUSTING LINKAGES (Op. 35 110 08)

Adjusting position control linkage

Proceed as follows.

1. Move the position control lever (1) fully forward on the quadrant and check that the distance (L) is between 15 and 20 mm (0.5906 and 0.7874 in.).

2. Move the external position control lever (1) fully rearward, against the spacer.

3. Connect the control linkage and adjust its length, if necessary.

4. Fasten the linkage using the lock nuts.

Adjusting draft control linkage

Test conditions:
− engine running at medium speed;
− allow the oil in the system to reach a temperature of 30 − 40 °C (86 − 104 °F).

Then proceed as follows:

5. Move the position control lever (1) fully forward on the quadrant and the draft control lever (2) to a distance (L1) of 15 − 20 mm (0.5906 − 0.7874 in.). from the beginning of the slot.

6. Move the draft control lever (2) fully back against the spacer.

7. Connect the control linkage and adjust its length if necessary.
…