Complete workshop & service manual with electrical wiring diagrams for Doosan DX700LC Crawler Excavator. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Doosan DX700LC Crawler Excavatorservice & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

“950106-00013E.pdf”
Doosan DX700LC Crawler Excavator Shop Manual
950106-00013E; Serial Number 5001 and Up; 1,190 pages

TABLE OF CONTENTS Safety................................... SP002135
Safety Specifications
Specification for DX700LC.............................. SP002136
General Maintenance
General Maintenance Procedures .................. SP000016
Standard Torques........................................... SP000813
Upper Structure
Cabin ........................ SP002148
Counterweight................................................. SP002141
Fuel Tank.................. SP002142
Fuel Transfer Pump (Opt)............................... SP002143
Swing Bearing................................................. SP002165
Swing Reduction Gear.................................... SP002149
Lower Structure and Chassis
Track Assembly .............................................. SP002146
Engine and Drive Train
Engine....................... SP002261
Drive Coupling (Main Pump)........................... SP000026
Hydraulics
Hydraulic System Troubleshooting, Testing and Adjustment ............... SP002166
Accumulator.............. SP000028
Center Joint (Swivel)....................................... SP002167
Cylinders................... SP002137
Swing Motor.............. SP002168
Travel Motor.............. SP002145
Travel Reduction Gear.................................... SP002144
Main Pump................ SP002169
Regulator of Main Pump ................................. SP002181
Gear Pump for Pilot ........................................ SP000033
Main Control Valve ......................................... SP002171
Remote Control Valve (Work Lever / Joystick) ..................................... SP002174
Travel Control Valve (with Damper)................ SP002172
Fan Motor (Fan Cooling Drive) ....................... SP002175
Fan Pump (Fan Cooling Drive) ....................... SP002176
Solenoid Valve Assembly ............................... SP001622
Breaker EPPR Valve (Opt) ............................. SP000192
Hydraulic Schematic (DX700LC) .................... SP002147
Electrical System
Electrical System ............................................ SP002140
Electrical Schematic (DX700LC) .................... SP002189
Attachments
Boom and Arm................................................ SP002138
Bucket....................... SP002139
Auto Grease System....................................... SP002216
…

EXCERPT:
INSTALLATION
1. Using a suitable lifting device, attach slings to four lift points on top of cab (Figure 9).
NOTE: Cabin weights approximately 315 kg (700 lb).
2. Lower cab into position on cab floor.
3. Install four mounting nuts from four corners of cabin floor (1, Figure 10).
NOTE: Mounting nut torque 21 kg•m (205 N•m, 150 lbf ft).
4. Install four M12 hex bolts (2, Figure 10) and two M10 hex bolts(3, Figure 10).
NOTE: Mounting nut torque
M12 - 11 kg•m (108 N•m, 80 lbf ft).
M10 - 6.5 kg•m (64 N•m, 47 lbf ft).
5. Once cab is mounted to floor, unhook lifting device.
6. Connect cabin wiring connectors to main harness.
7. Connect washer hose located at floor plate bottom.
8. Install air ducts (1, 2, 3, 4 and 5, Figure 11) right side of cabin step by step from the rear duct.
…