Complete workshop & service manual with electrical wiring diagrams for Lincoln LS 2004. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Lincoln LS 2004 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· M86 — Lincoln LS — six-cylinder, automatic
· M87 — Lincoln LS — eight-cylinder, automatic
· A — 3.9L, DOHC, EFI, eight cylinder
· S — 3.0L, DOHC, EFI, six cylinder

EXCERPT:
2004 Lincoln LS
Workshop Manual
Alphabetical Index
A B C D E F
G H I J K L
M N O P R S
T U V W Y
Table of Contents
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting
…
Safety Belt Procedure After a Collision
WARNING: All safety belt assemblies include retractors, buckles, front seat belt buckle support assemblies (slide bar), if equipped, shoulder belt height adjuster, if equipped, child safety seat tether bracket assemblies, if equipped, and attaching hardware should be inspected after any collision. All belt assemblies should be installed new unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a collision should also be inspected. New safety belt assemblies should be installed if either damage or incorrect operation is noted.
NOTE: The driver and front passenger seat belt system (including belt and retractor assembly, buckles, and height adjusters) must be replaced if the vehicle is involved in a collision that results in deployment of the front air bags and safety belt pretensioners.
Before installing a new safety belt assembly, the safety belt attaching areas must be inspected for damage and distortion. If the attaching points are damaged and distorted, the sheet metal must be worked back to its original shape and structural integrity.
1. Install the new safety belt(s). For additional information, refer to the procedure in this section. Carry out the Functional Test. For additional information, refer to Safety Belt System in this section.
…