Complete workshop & service manual with electrical wiring diagrams for Infiniti Q45 (FY33) 1997-2001. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Infiniti Q45 (FY33) 1997-2001 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

TABLE OF CONTENTS
QUICK REFERENCE INDEX
GENERAL INFORMATION
MAINTENANCE
ENGINE MECHANICAL
ENGINE LUBRICATION & COOLING SYSTEMS
ENGINE CONTROL SYSTEM
ACCELERATOR CONTROL, FUEL & EXHAUST SYSTEMS
CLUTCH
MANUAL TRANSAXLE
AUTOMATIC TRANSAXLE
FRONT AXLE & FRONT SUSPENSION
REAR AXLE & REAR SUSPENSION
BRAKE SYSTEM
STEERING SYSTEM
RESTRAINT SYSTEM
BODY & TRIM
HEATER & AIR CONDITIONER
ELECTRICAL SYSTEM
ALPHABETICAL INDEX

EXCERPT:
Disassembly
1. Prior to disassembling, measure pinion rotating torque. Record the pinion rotating torque as a reference.
Refer to step 12 of “Adjustment” for reference torque data.
Before measuring, disconnect cylinder tube and drain fluid.
Use soft jaws when holding steering gear housing. Handle gear housing carefully, as it is made of aluminum. Do not grip cylinder in a vise.
2. Remove pinion gear.
Be careful not to damage pinion gear when removing pinion seal ring.
3. Remove tie-rod outer sockets and boots.
4. Loosen tie-rod inner socket by prying up staked portion, and remove socket.
5. Remove retainer.
6. Remove pinion assembly.
7. Use a 2 to 2.5 mm (0.079 to 0.098 in) diameter drill to completely remove staked portion of gear housing end.
8. Remove gear housing end cover assembly with Tool.
9. Draw out rack assembly.
10. Remove rack seal ring.
Using a heat gun, heat rack seal to approximately 40°C (104°F).
Remove rack seal ring.
Replace rack seal ring and O-ring with new ones.
Be careful not to damage rack.
11. Remove center bushing and rack oil seal using tape wrapped socket and extension bar.
Do not scratch inner surfaces of pinion housing.
Inspection
…
Thoroughly clean all parts in cleaning solvent or Genuine Nissan
PSF II or equivalent. Blow dry with compressed air, if
available.
BOOT
I Check condition of boot. If cracked excessively, replace it.
I Check boots for accumulation of power steering fluid.
RACK
Thoroughly examine rack gear. If damaged, cracked or worn,
replace it.