Complete workshop & service manual with electrical wiring diagrams for Hyundai Construction Skid Steer Loader HSL810. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Hyundai Construction Skid Steer Loader HSL810 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

EXCERPT:
TABLE OF CONTENTS
SKID STEER LOADER HSL810
FOREWORD
SECTION 1
GENERAL
Group 1 Safety Hints
Group 2 Specifications
Group 3 Maintenance
SECTION 2
HYDRAULIC SYSTEMUNCTION
Group 1 Major components
Group 2 Hydraulic component testing
Group 3 Self level valve
Group 4 Auxiliary pump
Group 5 Main pump
Group 6 Travel motor
Group 7 Main control valve
Group 8 Boom and bucket cylinder
SECTION 3
ELECTRICAL SYSTEM
Group 1 Component location
Group 2 Wiring diagram
Group 3 Electrical component specification
Group 4 Connector destination
SECTION 4
POWER TRAIN
Group 1 Power train component
Group 2 Front and rear axle
Group 3 Gear box
SECTION 5
CONTROL
Group 1 Hand control
Group 2 Foot control
Group 3 Parking brake
Group 4 Attachment holder
SECTION 6
TROUBLE SHOOTING
Group 1 Travel hydraulics
Group 2 Boom and bucket hydraulic
Group 3 Power train
Group 4 Control
Group 5 Electrical system
…
GROUP 2 FOOT CONTROL
Be sure engine turn off and boom and bucket lowered on ground before removal and installation work of foot control device.
1. ADJUSTMENT
Raise operators cab to service position.
Refer to operator's manual at page 4-14.
Check pedal lock(4) by move seat bar to up and down.
Adjust pedal lock by turn lock bolt(13,15).
2. REMOVAL
Lower boom and bucket on ground and block the loader securely with four wheels clear of the ground.
Raise operators cab to service position.
Refer to operator's manual at page 4-14.
Remove bolts(31) secure to rubber boots.
Loosen front cover bolts(32) and remove front cover(33).
Remove clevis pin(9,10) from link plate.
Loosen the mounting bolts(12) and remove foot pedal assembly(1).
…