Complete digital official shop repair servicemanual contains service, maintenance, and troubleshooting information for the Toyota RAV4 1994-2016. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Toyota RAV4 1994-2016 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

1.7 GB, 21,224 pages, bookmarked, Searchable, Printable, high quality PDF

EXCERPT:
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
DISASSEMBLY
1. REMOVE OIL FILLER CAP SUB-ASSEMBLY
2. REMOVE SPARK PLUG
3. REMOVE CAMSHAFT TIMING CONTROL VALVE
ASSEMBLY (See page ES-440)
4. REMOVE VVT SENSOR (See page ES-443)
5. REMOVE WATER OUTLET
(a) Remove the 2 bolts, 4 nuts and water outlet.
(b) Remove the 2 gaskets and O-ring.
6. REMOVE OIL PIPE
(a) Remove the bolt, 2 union bolts and oil pipe.
(b) Remove the oil control valve filter RH and gaskets.
7. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
(for Bank 1)
(a) Remove the 12 bolts, cylinder head cover and gasket.
HINT: Make sure the removed parts are returned to the same places they were remove a from.
8. REMOVE NO. 1 OIL PIPE
(a) Remove the 2 union bolts and oil pipe.
(b) Remove the oil control valve filter LH and gaskets.
9. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY (for Bank 2)
(a) Remove the 12 bolts, cylinder head cover and
gasket.
HINT: Make sure the removed parts are returned to the same places they were remove a from.
10. REMOVE FRONT NO. 1 ENGINE MOUNTING
BRACKET
(a) Remove the 6 bolts and mounting bracket.
11. REMOVE WATER INLET HOUSING (See page CO-12)
12. REMOVE OIL FILTER CAP ASSEMBLY (See page LU-4)
13. REMOVE OIL FILTER ELEMENT (See page LU-5)
14. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY (See page LU-12)
15. REMOVE OIL STRAINER SUB-ASSEMBLY (See page LU-13)
16. REMOVE OIL PAN SUB-ASSEMBLY (See page LU-13)
17. REMOVE OIL PAN BAFFLE PLATE
(a) Remove the 7 bolts and baffle plate.
...