Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Mercedes-Benz SLK350 2004-2016. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Mercedes-Benz SLK350 2004-2016 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
Mercedes-Benz SLK350 - ACCESSORIES & BODY, CAB Rear Wall & Rear End - 171 Chassis
...
Fig. 28: Identifying Welding Areas On Rear Cross Member
1. Install rear cross member (2) with straightening set (3), install and fasten with clamping pliers.
2. Weld in rear cross member (2) with (areas F, G, H, I, J, K, L, M and N).
3. Remove straightening set (3).
4. Coat rear inner cross member with zinc dust paint
Fig. 29: Identifying Welding Areas On Rear Centre Section
5. Install rear center section (1) with straightening set (4), fit and fasten with clamping pliers.
6. Weld in rear center section (1) with (areas A, B and C).
7. Remove straightening set (4).
8. Finish welding on rear center section (1) with
9. Weld in rear center section (1) with (area D).
Fig. 30: Identifying Welding Areas On Rear Centre Section (Area D)
10. Weld in rear center section (1) with (area E).
11. Clean weld with round wire brush (area E).
12. Remove grinding and drilling chips with wet/dry vacuum cleaner.
Fig. 31: Identifying Straightening Set And Welding Areas In Rear Center Section (Area E)
REMOVE/INSTALL UPPER TANK COVER - AR64.20-P-1080V
MODEL 171
Fig. 32: Identifying Upper Tank Cover Bolts And Nuts
...