Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2007-2015 Infiniti G35, G37, Q40 (V36 Series). Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for 2007-2015 Infiniti G35/G37/Q40 (V36 Series) is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
BRAKE PEDAL
REMOVAL AND INSTALLATION
BRAKE PEDAL
Exploded View
1. Brake pedal stroke sensor (with precrash seat belt)
2. Clevis pin
3. Brake pedal assembly
4. Brake pedal pad
5. Clip
6. Snap pin
7. Lock nut
8. ASCD brake switch
9. Stop lamp switch
Removal and Installation INFOID:0000000010992596
REMOVAL
1. Remove instrument lower panel LH. Refer to IP-12, "Exploded View".
2. Remove steering column assembly. Refer to ST-15, "Exploded View".
3. Disconnect the stop lamp switch and ASCD brake switch harness connectors.
4. Disconnect the brake pedal stroke sensor harness connector. (With pre-crash seat belt)
CAUTION: Never removing brake pedal stroke sensor. (With pre-crash seat belt)
5. Turn the stop lamp switch counterclockwise to remove the stop lamp switch.
6. Loosen the lock nut for the ASCD brake switch and remove the ASCD brake switch.
7. Remove snap pin (1) and clevis pin (2) from clevis of brake booster.
8. Remove the cowl top. Refer to EXT-24, "Exploded View".
9. Remove the instrument panel. Refer to IP-12, "Exploded View".
10. Slide the steering member rearward. Refer to HA-50, "Exploded View".
11. Remove the brake pedal assembly.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Apply the multi-purpose grease to the clevis pin and the mating faces. (Not necessary if grease has been already applied)
NOTE:
The clevis pin may be inserted in either direction.
Inspection and Adjustment
INSPECTION AFTER REMOVAL
• Check the following items and replace the brake pedal assembly if necessary.
- Check the brake pedal upper rivet (made by aluminum) (A) for deformation.
- Check the brake pedal for bend, damage, and cracks on the welded parts.
- Check the lapping length (X) of sub-bracket (B) and slide plate (C).
• Check clevis pin and plastic stopper (A) for damage and deformation.
If any is found, replace clevis pin.
ADJUSTMENT AFTER INSTALLATION
Perform the brake pedal adjustment after installing the brake pedal assembly. Refer to BR-9, "Inspection and Adjustment".
...