Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Hyundai Veracruz 2007-2015. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Hyundai Veracruz 2007-2015 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2012 ENGINE
Intake & Exhaust System - Veracruz
INTAKE MANIFOLD
COMPONENTS AND COMPONENTS LOCATION
Fig. 1: Identifying Intake & Exhaust System Components With Torque Specifications
REPAIR PROCEDURES
Removal
1. Disconnect the AFS connector (A) and the breather hose (B).
2. Remove the air cleaner body (D) and the intake hose (C).
Fig. 2: Identifying AFS Connector
3. Disconnect the RH front and rear oxygen sensor connectors (A), the power steering sensor connector (B), the RH injector harness connector (C) and the VIS solenoid valve connector (D).
Fig. 3: Identifying Rear Oxygen Sensor Connectors
4. Disconnect the PCSV connector (A), the MAP sensor connector (B) and the PCSV hose.
Fig. 4: Identifying PCSV Connector
5. Disconnect the ETC connector (A) and the knock sensor connector (B).
Fig. 5: Identifying ETC Connector
6. Disconnect the water hoses (B) from ETC.
7. Disconnect the PCV (C) hose.
Fig. 6: Identifying Water Hoses
8. Disconnect brake vacuum hose.
9. Remove the surge tank stays (A).
Fig. 7: Identifying Surge Tank Stays (1 Of 2)
Fig. 8: Identifying Surge Tank Stays (2 Of 2)
10. Remove the surge tank (A).
Fig. 9: Identifying Surge Tank
11. Disconnect the breather Pipe assembly (A).
Fig. 10: Identifying Breather Pipe Assembly
12. Disconnect the LH injector harness connectors.
13. Remove the intake manifold (A) and gasket.
Fig. 11: Identifying Intake Manifold
Installation
1. Install the intake manifold and new gasket on the cylinder head.
Tightening torque
1st: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
2nd: 18.62 ~ 23.52 N.m
...