Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Saturn Outlook 2006-2010. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Saturn Outlook 2006-2010 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2010 ENGINE Engine Mechanical - 2.8L, 3.0L, 3.2L, or 3.6L - Repair Instructions - On Vehicle - Acadia, Enclave, Outlook & Traverse
ENGINE SUPPORT FIXTURE
SPECIAL TOOLS
J 28467-B Universal Engine Support Fixture. See Special Tools .
J 28467-7A Bolt Hook. See Special Tools .
J 28467-34 Lift Hook Wing Nut and Washer. See Special Tools .
J-41803-9 Engine Lift Hook
J 42451-1 Engine Support Adapter
INSTALLATION PROCEDURE
Fig. 4: Identifying Special Tool - J 42451-1
1. Remove the injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
2. Remove the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement .
3. Remove the right engine strut mount. Refer to Engine Mount Strut Replacement - Right Side.
4. Install the J 42451-1 to the right side of the engine.
5. Remove the Mass air flow sensor. Refer to Mass Airflow Sensor with Intake Air Temperature Sensor Replacement
Fig. 5: Identifying Special Tool - J-41803-9
6. Install the J-41803-9 to the left side front of the engine.
Fig. 6: Identifying Special Tools - J 28467-3 & J 43405
7. Using J 28467-B , install the ends of the strut tower tube J 28467-518 (1) to the engine support adapter legs (P/N) 48059 (2). See Special Tools.
Fig. 7: Identifying Special Tools - J 28467-3 & J-48059
8. Place the strut tower tube J 28467-518 and the (P/N) 48059 on top of both the left and right fender lips, over the engine rear lift bracket.
Fig. 8: Identifying Special Tools - J 36462-1A & J 28467-51
9. Install the radiator shelf tube J 36462-1A (2) on top of the strut tower tube J 28467-518 (1) above the left side of the engine.
Fig. 9: Identifying Special Tools - J 28467-4A & J 36462-1A
10. Install the round tube of the front support assembly J 28467-4A through the large hole in the radiator shelf tube J 36462-1A.
11. Remove the upper tie bar cover.
12. Locate the J 28467-4A front support assembly to the upper tie bar.
13. Install the J 28467-9 quick-release pin through the bottom hole in the J 28467-4A front support assembly.
14. Install the J 28467-9 quick-release pin through the hole above the J-36462-1A radiator shelf tube.
...