Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Kia Amanti 2002-2011. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Kia Amanti 2002-2011 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2009 ENGINE Mechanical - Amanti
INTAKE AND EXHAUST SYSTEM
INTAKE MANIFOLD
COMPONENTS
Fig. 274: Identifying Intake Manifold Components With Torque Specifications
REMOVAL
1. Disconnect AFS (A) and breather hose (B).
2. Remove air cleaner body (D) and intake hose (C).
Fig. 275: Identifying Intake Air Hose And Air Cleaner Body
3. Disconnect RH oxygen sensor connector (A).
Fig. 276: Identifying RH Oxygen Sensor Connector
4. Disconnect RH injector connector and ignition coil connector.
5. Disconnect PCSV connector (A), MAP sensor connector (B) and PCSV hose.
Fig. 277: Identifying PCSV Connector, MAP Sensor Connector And PCSV Hose
6. Disconnect ETC connector (A) and knock sensor connector (B).
Fig. 278: Locating ETC Connector And Knock Sensor Connector
7. Disconnect water hoses (B) from ETC.
8. Disconnect PCV (C) hose.
Fig. 279: Locating PCV Hose
9. Disconnect brake vacuum hose.
10. Remove surge tank stay (A).
Fig. 280: Identifying Surge Tank Stay
11. Remove connector bracket from surge tank or connectors (2EA).
12. Remove surge tank (A).
Fig. 281: Identifying Surge Tank
13. Disconnect breather pipe assembly (A).
Fig. 282: Locating Breather Pipe Assembly
14. Disconnect LH injector connector.
15. Remove intake manifold (A) and gasket.
Fig. 283: Identifying Intake Manifold And Gasket
INSTALLATION
1. Install intake manifold and new gasket on the cylinder head.
Tightening torque
1st: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
2nd : 18.62 ~ 23.52 N.m (1.9 ~ 2.4 kgf.m, 13.74 ~ 17.36 lb-ft)
3rd : Repeat 2nd step twice or move.
NOTE: Be careful of the installation direction.
a - h : 1st step order
1 ~ 8 : 2nd step order
...