Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Pontiac Montana 1997-2009. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Pontiac Montana 1997-2009 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2009 Pontiac Montana SV6
2009 ENGINE Engine Mechanical - 3.9L - Montana SV6
REPAIR INSTRUCTIONS - ON VEHICLE
INTAKE MANIFOLD COVER REPLACEMENT
Removal Procedure
Fig. 6: Identifying Engine Manifold Cover
1. Remove the engine oil fill cap.
2. Remove the oil fill pipe.
3. Pull up on the cover in order to disengage the cover from the studs.
Installation Procedure
Fig. 7: Identifying Engine Manifold Cover
1. Align the cover to the studs on the engine, push down on the cover above the studs in order to engage the cover to the studs.
2. Install the oil fill pipe.
3. Install the engine oil fill cap.
DRIVE BELT REPLACEMENT
Removal Procedure
Fig. 8: Identifying Drive Belt Routing
1. Rotate the drive belt tensioner clockwise in order to release the tensioner spring tension.
2. Remove the drive belt.
Installation Procedure
Fig. 9: Identifying Drive Belt Routing
1. Rotate the drive belt tensioner clockwise in order to release the tensioner spring tension.
2. Install the drive belt.
DRIVE BELT IDLER PULLEY REPLACEMENT
Removal Procedure
Fig. 10: View Of Drive Belt Idler Pulleys
1. Remove the drive belt. Refer to Drive Belt Replacement.
2. Remove the required drive belt idler pulley bolt.
3. Remove the drive belt idler pulley.
Installation Procedure
Fig. 11: View Of Drive Belt Idler Pulleys
1. Install the drive belt idler pulley.
CAUTION: Refer to Fastener Caution .
2. Install the required drive belt idler pulley bolt and tighten to 50 N.m (37 lb ft) .
3. Install the drive belt. Refer to Drive Belt Replacement.
DRIVE BELT TENSIONER REPLACEMENT
Removal Procedure
...