Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2005-2006 Saturn Relay. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for 2005-2006 Saturn Relay is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2007 ENGINE Engine Mechanical - 3.9L - Relay
OFF-VEHICLE REPAIR INSTRUCTIONS
Draining Fluids and Oil Filter Removal
Fig. 378: View Of Oil Drain Plug
Courtesy of GENERAL MOTORS CORP.
1. Remove the oil pan drain plug.
2. Drain the engine oil.
Fig. 379: View Of Oil Filter
3. Remove the oil filter.
Fig. 380: Identifying Left Side Coolant Drain Plug
4. Remove the coolant drain plug from the left side.
Fig. 381: Locating Upper Inlet Hose Clamp
5. If equipped with an oil cooler (RPO-KC4), reposition the upper inlet hose clamp (1).
6. Remove the oil cooler inlet hose from the block outlet.
Fig. 382: Identifying Right Side Coolant Drain Plug
7. If not equipped with an oil cooler (RPO-KC4), remove the coolant drain plug from the right side.
8. Drain the coolant.
Crankshaft Balancer Removal
Tools Required
J 41816 Crankshaft Balancer Remover. See Special Tools.
EN 46359 Puller End Protector. See Special Tools.
Fig. 383: Identifying Crankshaft Balancer Bolt & Washer
1. Remove the crankshaft balancer bolt and washer.
Fig. 384: Removing Crankshaft Balancer
NOTE: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the alignment of this component using a power-assisted tool, and this can damage the component.
2. Remove the crankshaft balancer using the J 41816 along with EN 46359 . See Special Tools.
Engine Flywheel Removal (Automatic Transmission)
Fig. 385: Identifying Flywheel & Bolts (Automatic Transmission)
1. Remove the flywheel bolts.
2. Remove the flywheel.
Drive Belt Tensioner Removal
Fig. 386: Identifying Drive Belt Tensioner & Bolt
1. Remove the drive belt tensioner bolt.
2. Remove the drive belt tensioner.
Engine Mount Strut and Engine Lift Bracket Removal
Fig. 387: Identifying Engine Mount Strut & Engine Lift Bracket Bolts
1. Remove the engine mount strut and engine lift bracket bolts.
2. Remove the engine mount strut and engine lift bracket.
Engine Mount Support and Strut Bracket Removal
...