Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Alfa Romeo 156 1997-2007. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Alfa Romeo 156 1997-2007 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

MAKE: Alfa Romeo
MODEL: 156 (2.4 JTD 20V, 2.4 JTD 10V, 2.0 JTS, 1.9 JTD 16V, 1.9 JTD 8V, 3.2 V6, 2.5 V6, 2.0 JTS, 1.8 TS, 1.6 TS, 2.0 TS)
YAER: 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007
LANGUAGE: EN/DE/ES/FR/IT/NL/PL/GK/PT/CZ/TR

EXCERPT (1997-2007 Alfa Romeo 156 Service/Repair Manual):
Secure and support the engine for hoisting using a hydraulic hoist fitted with suitable chains.
Fit the engine on the overhauling stand using suitable tools.
1. It is possible to use the tool to support the engine on the overhauling stand.
Release the engine from the hoist.
Secure and support the engine for hoisting using a hydraulic hoist fitted with suitable chains.
Undo the fixings and remove the engine complete with supporting tools.
Undo the fixings and remove the supporting tools from the engine, then place them down.
If the end float of the crankshaft is not within the recommended values, when refitting, reface the seat in the cylinder block/crankcase and use suitable oversize thrust washers.
6. Undo bolts (6a) and remove connecting rod caps (6b).
7. Remove the lower main journal half-bearings.
8. Remove the crankshaft.
9. Remove the upper main journal half-bearings.
10. Remove the thrust washers.
11. Undo the bolts (11a) and remove the jets (11b) from the crankcase.
12. Undo the bolt (12a) and remove the rpm and timing sensor (12b).
13. Remove the minimum engine oil pressure warning light sensor.
1. Undo bolts (1a) and remove flange (1b) with the oil return pipe to the sump from the turbocharger.
2. Undo connector (2a) and remove the oil supply pipe to the turbocharger (2b).
3. Undo bolts (3a) and remove the turbocharger bracket (3b).
Rotate the cylinder block/crankcase through 90° on the overhauling stand.
Undo the bolts and remove the crankcase from the mounting brackets, then place it on a workbench.
Unscrew the bolts and remove the flywheel protection.
- 1028H60 piston, pin set - replace
Undo the bolts and remove the oil inlet from the oil pump.
...