Complete factory shop manual including electrical wiring diagrams for KTM 450 SX, 505 SX ATV 2010. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page to save your precious time.

This repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

"'10 450 SX, 505 SX ATV.pdf"
247 pages; KTM 450 SX ATV, 505 SX ATV REPAIR MANUAL 2010

EXCERPT:
13/BRAKE SYSTEM
Hand brake lever, parking brake
The hand brake lever 1 is located on the right side of the handlebar and operates the front brakes.
The hand brake lever is combined with the parking brake, which blocks the front wheels to prevent the vehicle from rolling away.
To activate the parking brake, pull the hand brake lever, push the locking pawl 2 down and release the hand brake lever.
Possible states
• Hand brake lever in basic position – Front wheels are not locked.
• Hand brake lever pulled and locked in position – Front wheels are locked.
16.2 Checking the free travel of the hand brake lever
Warning: Danger of accidents Brake system failure.
– If there is no free travel on the hand brake lever, pressure builds up in the front brake circuit. The front brake can fail due to overheating. Adjust free travel on hand brake lever according to specifications.
– Push the hand brake lever forward and check free travel A.
Free travel of hand brake lever ≥ 3 mm (≥ 0.12 in)
» If the free travel does not meet specifications:
– Adjust the basic position of hand brake lever. ( p. 88)
16.3 Adjusting basic position of hand brake lever
– Check the free travel of the hand brake lever. ( p. 88)
– Adjust the basic setting of the hand brake lever to your hand size by turning adjusting screw 1.
Info
Pull the brake lever forward and turn the adjusting screw.
Turn the adjusting screw clockwise to increase the distance between the hand brake lever and the handlebar.
Turn the adjusting screw counterclockwise to decrease the distance between the hand brake lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
Do not make any adjustments while riding!