Complete workshop service manual with electrical wiring diagrams for '92-'96 Honda CBR1000F Motorcycle. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

"'92-'95 CBR1000F.pdf"
421 pages

"'93-'96 CBR1000F.pdf"
265 pages

EXCERPT:
TABLE OF CONTENTS
General Information
Frame/Body Panels/Exhaust System
Maintenance
Lubrication System
Fuel System
Cooling System
Engine Removal/Installation
Cylinder Head/Cylinder /Piston
Clutch/Gearshift Linkage
Crankshaft/Transmission
Front Wheel/Suspension/Steering
Rear Wheel/Suspension
Brake System
Charging System/Alternator
Ignition System
Electric Starter
Lights/Meters/Switches
Wiring Diagrams
Technical Feature
Troubleshooting
...
2. Frame/Body Panels/Exhaust System
Service Information
Pivot Cover
Troubleshooting
Pivot Under Cover
Body Panel Locations
Lower Fairing
Side Cover
Upper Fairing
Seat
Fuel Tank
Seat Cowl
Exhaust System
Rear Fender
Service Information
• Gasoline is extremely flammable and is explosive under certain conditions.
• Serious burns may result if the exhaust system is not allowed to cool before components are removed or serviced.
• Work in a well ventilated area. Smoking or allowing flames or sparks in the working area or where gasoline is stored can cause a fire or explosion.
• This section covers removal and installation of the frame body panels, fuel tank and exhaust system.
• Always replace the exhaust pipe gaskets when removing the exhaust pipe from the engine.
• When installing the exhaust pipe, first install all the fasteners loosely. Always tighten the exhaust clamps first, then tighten the mounting fasteners. If you tighten the mounting fasteners first, the exhaust pipe may not seat properly.
• Always inspect the exhaust system for leaks after installation.
Troubleshooting
Excessive Exhaust Noise
• Broken exhaust system
• Exhaust gas leak
• Poor Performance
• Deformed exhaust system
• Exhaust gas leak
• Clogged muffler
...