Complete workshop & service manual with electrical wiring diagrams for Honda ST1300A 2002-2007. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Honda ST1300A 2002-2007 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

EXCERPT:
FUEL SYSTEM (Programmed Fuel Injection)
FUEL PUMP
INSPECTION
Turn the ignition switch ON and confirm that the fuel pump operates for a few seconds.
If the fuel pump does not operate, inspect as follows:
Remove the seat (page 2-5) and left side cover (page 2-6).
Disconnect the fuel pump 3P (Black) connector.
Turn the ignition switch ON and measure the voltage between the terminals.
Connection: Brown(+)- Green(-)
There should be battery voltage for a few seconds.
If there is battery voltage, replace the fuel pump.
If there is no battery voltage, inspect the following:
- Main fuse 30A
- Sub fuse 10A
- Engine stop switch (page 22-25)
- Fuel cut-off relay (page 5-56)
- Engine stop relay (page 5-85)
- Bank angle sensor (page 5-84)
- ECM (page 5-87)
REMOVAL
NOTICE
• Before disconnecting the fuel hoses, release the fuel pressure by loosening the fuel feed hose banjo bolt at the fuel tank.
• Always replace the sealing washers when the fuel feed hose banjo bolt is removed or loosened.
Remove the lower fuel tank (page 5-57).
Remove the fuel pump mounting nuts.
…