Complete workshop & service manual with electrical wiring diagrams for Suzuki DR650R, DR650SE, DR650S, DR650RS 1990-2001 It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Suzuki DR650R, DR650SE, DR650S, DR650RS 1990-2001 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

“DR650SE '96-'01.pdf”
MAKE: Suzuki
YEAR: 1996 1997 1998 1999 2000 2001
MODEL: DR650SE (DR650SE-T/V/W/X/Y/K1)
(DR650SET, DR650SEV, DR650SEW, DR650SEX, DR650SEY, DR650K1)
PAGE: 263

“DR650R_S '90-'93.pdf”
Suzuki DR650R, DR650RS 1990-1993 Service Manual; 281 pages
DR650RL, DR650SL, DR650RS, DR650RM, DR650SM, DR650RSM, DR650RSEM, DR650RSEN, DR650RSEP

EXCERPT:
ELECTRICAL SYSTEM 6-2
BATTERY
• The MF battery used in this vehicle does not require maintenance as inspection of electrolyte level and replenishment of water.
• No hydrogen gas is produced during normal charging of the battery, but such gas may be produced when it is overcharged. Therefore, do not bring fire near the battery while it is being charged.
• Note that the charging system for the MF battery is different from that of an ordinary battery. Do not replace with an ordinary battery.
CONNECTING BATTERY
• When disconnecting terminals from the battery for disassembly or servicing, be sure to disconnect the negative ( 8 ) terminal first.
• When connecting terminals to the battery, be sure to connect the positive ( (E) ) terminal first.
• If the terminal is found corroded, remove the battery, pour warm water over it and clean with a wire brush.
• Upon completion of connection, apply grease lightly.
• Put a cover over the positive ( (E) ) terminal.
WIRING PROCEDURE
• Route the wire harness properly according to "WIRE HARNESS ROUTING" (Refer to pages 7-12 and 13.).
USING POCKET TESTER
• Be sure to use positive ( (E) ) and negative ( 8 ) probes of the tester properly. Their false use may cause damage in the tester.
• If the voltage and current values are not known, start measuring in the higher range.
• Before measuring the resistance and after changing the resistance range, always perform 0 Q adjustment.
• Taking a measurement where voltage is applied in the resistance range may cause damage in the tester. When measuring resistance, check to make sure that no voltage is applied there .
• After using the tester, turn the switch to the OFF position.
…