Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Cadillac Escalade 1999-2014. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Cadillac Escalade (Escalade/Escalade ESV/Escalade ESV Luxury/Escalade ESV Platinum/Escalade ESV Premium/Escalade EXT/Escalade EXT Luxury/Escalade EXT Premium/Escalade Hybrid/Escalade Hybrid Platinum/Escalade Platinum/Escalade Luxury/Escalade Premium/) is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
MOLDING REPLACEMENT - FRONT BUMPER CAP
Removal Procedure
1. Open the hood.
2. Remove the upper air baffle. Refer to Radiator Air Baffle and Deflector Replacement - Upper in Engine Cooling.
3. Remove the front grille. Refer to Grille Replacement (Cadillac) or Grille Replacement (Avalanche) or Grille Replacement (Chevrolet) or Grille Replacement (GMC) in Exterior Trim.
4. Remove the front bumper. Refer to Bumper Replacement - Front (Old Style) .
5. Remove the front bumper fascia cap by depressing all the tabs and pulling up.
Installation Procedure
1. Position the fascia cap tabs to the slots in the bumper.
2. Install the front bumper cap to the bumper pressing into place until fully seated.
3. Install the front bumper. Refer to Bumper Replacement - Front (Old Style) .
4. Install the front grille. Refer to Grille Replacement (Cadillac) or Grille Replacement (Avalanche) or Grille Replacement (Chevrolet) or Grille Replacement (GMC) in Exterior Trim.
5. Install the upper air baffle. Refer to Radiator Air Baffle and Deflector Replacement - Upper in Engine Cooling.
6. Close the hood.

Installation Procedure
1. Install the fog lamps, if equipped. Refer to Fog Lamp Replacement - Front in Lighting Systems.
2. Install the air deflector to the bumper if necessary. Refer to Air Deflector Replacement - Front Bumper Fascia.
3. Position the front bumper assembly on the vehicle.
IMPORTANT: Tighten the bolts in the following sequence.
4. Install the retaining bolts (1, 2) to the front bumper.
Tighten:
1. Tighten the bracket bolt (1) to 85 N.m (63 lb ft).
2. Tighten the bracket bolt (2) to 85 N.m (63 lb ft).
3. Tighten the brace bolt to 55 N.m (41 lb ft).
5. Connect the electrical connector to the fog lamps, if equipped.
6. Install the front grille Refer to Grille Replacement (Cadillac) or Grille Replacement (Avalanche) or Grille Replacement (Chevrolet) or Grille Replacement (GMC) in Exterior Trim.
...