Complete workshop & service manual with electrical wiring diagrams for Bobcat 329 Compact Excavator. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Bobcat 329 Compact Excavator service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

329 6904770 (10-07) - 329 Compact Excavator Operation & Maintenance Manual.pdf
329 6986945 (2-08) - 329 Compact Excavator Operation & Maintenance Manual.pdf
6904771 (10-09) - 329 Compact Excavator Service Manual.pdf
6986946 (10-09) - 329 Compact Excavator Service Manual.pdf

EXCERPT:
CONTENTS
FOREWORD. . . . . . . . II
SAFETY INSTRUCTIONS . . . . . . . . . . . IV
FIRE PREVENTION . . . . . . . . .VI
SERIAL NUMBER LOCATIONS . . . . . .VIII
DELIVERY REPORT. . . . . . . . . IX
EXCAVATOR IDENTIFICATION . . . . . . . X
SAFETY AND MAINTENANCE. . . . . 10-01
HYDRAULIC SYSTEM . . . . . . . . . . . 20-01
UNDERCARRIAGE. . . . . . . 30-01
UPPERSTRUCTURE & SWING SECTION . . . . . . . . . 40-01
ELECTRICAL SYSTEM AND ANALYSIS . . . . 50-01
ENGINE SERVICE . . . . . . . 60-01
HEATER . . . . . . . . 70-01
SPECIFICATIONS. . . . . SPEC-01
…
SAFETY AND MAINTENANCE
HYDRAULIC SYSTEM
UNDERCARRIAGE
UPPERSTRUCTURE & SWING SECTION
ELECTRICAL SYSTEM AND ANALYSIS
ENGINE SERVICE
HEATER
SPECIFICATIONS
…
TRANSPORTING THE EXCAVATOR ON A TRAILER
Loading And Unloading
When transporting the machine, observe the rules, motor vehicle laws, and vehicle limit ordinances. Use a
transport and towing vehicle of adequate length and capacity.
Secure the parking brakes and block the wheels of the transport vehicle.
Align the ramps with the center of the transport vehicle.
Secure the ramps to the truck bed and be sure ramp angle does not exceed 15 degrees.
Use metal loading ramps with a slip resistant surface.
Use ramps that are the correct length and width and can support the weight of the machine.
The rear of the trailer must be blocked or supported when loading or unloading the machine to prevent the front of the transport vehicle from raising.
Determine the direction of the track movement before moving the machine (blade forward).
Engage the upperstructure slew lock.
…