Complete workshop repair & service manual with electrical wiring diagrams for Bobcat 463 Loader. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Bobcat 463 Loader service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

6901175 (6-02) - 463 Loader Operation & Maintenance Manual.pdf
6901175 (08–01) - 463 Loader Operation & Maintenance Manual.pdf
6901177 (3-06) - 463 Loader Service Manual.pdf
6901811 (8-04) - 463 Loader Operation & Maintenance Manual.pdf
6901811 (10-04) - 463 Loader Operation & Maintenance Manual.pdf
6901812 (3-06) - 463 Loader Service Manual.pdf
6903710 (5-07) - 463 Operation & Maintenance Manual.pdf
6903710 (12-04) - 463 Loader Operation & Maintenance Manual.pdf
6903711 (8-07) - 463 Loader Service Manual.pdf

EXCERPT:
CONTENTS
FOREWORD. . . . . . . . . . II
SAFETY INSTRUCTIONS . . . . . . . . . . V
SERIAL NUMBER LOCATIONS . . . . . . IX
DELIVERY REPORT. . . . IX
BOBCAT LOADER IDENTIFICATION . . . . . . . . . . . . X
SAFETY AND MAINTENANCE. . . . 10-01
HYDRAULIC SYSTEM . . . . . . . . . . 20-01
HYDROSTATIC SYSTEM. . . . . . . . 30-01
DRIVE SYSTEM . . . . 40-01
MAIN FRAME . . . . . . 50-01
ELECTRICAL SYSTEM & ANALYSIS . . . . . . . . . 60-01
ENGINE SERVICE . . . . . . . . . . . . . 70-01
SPECIFICATIONS . . . . . . . . . . SPEC-01
…
TRACTION LOCK (CONT’D)
Removal And Installation (Cont’d)
IMPORTANT
Failure to use LOCTITE may allow the traction lock assembly to loosen up which can cause damage to the traction lock system.
Figure 60-100-3
Remove the shaft mounting bolt (Item 1) [Figure 60-100-3], washer and spring from the assembly shaft (Item 2) [Figure 60-100-3]. Remove the wedge (Item 3) [Figure 60-100-3] and inspect all parts for damage or wear. Replace if necessary.
Installation: Thoroughly clean and dry the shaft mounting bolt (Item 1) [Figure 60-100-3], the shaft (Item
2) [Figure 60-100-3], and wedge (Item 3) [Figure 60-100-3]. Use LOCTITE #242 when assembling these parts to the traction lock assembly.
Refer to ELECTRICAL SYSTEMS & ANALYSIS, Page 60-01 for the traction lock inspection procedure.
…