Complete workshop & service manual with electrical wiring diagrams for Bobcat 953 Loader. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Bobcat 953 Loader service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

6724087 (9-98) - 953 Operation & Maintenance Manual.pdf
6724352 (11-95) - 953 Service Manual.pdf

EXCERPT:
CONTENTS
FOREWORD . . . . . . ii
SAFETY INSTRUCTIONS . . . . . . . . . . . v
SERIAL NUMBER LOCATIONS . . . . . vii
DELIVERY REPORT . . . . . . . vii
BOBCAT LOADER IDENTIFICATION . . . . . . . . . viii
PREVENTIVE MAINTENANCE . . . . . . 1–1
HYDRAULIC SYSTEM . . . . . 2–1
HYDROSTATIC SYSTEM . . . . . . . . . 3–1
DRIVE SYSTEM . . . . . . . . . . 4–1
MAIN FRAME . . . . . 5–1
ELECTRICAL SYSTEM . . . . . . . . . . . 6–1
ENGINE SERVICE . . . . . . . . 7–1
BICS™ SYSTEM . . . . . . . . . . 8–1
SPECIFICATIONS . . . . . . . . . 9–1
…
PARKING BRAKE
Removal and Installation
Raise the loader operator cab. (See Page 1–1.)
Remove the (2) mounting bolts (Item 1) [A] from the brake pedal mounting bracket.
Installation: Tighten the mounting bolts to 25–28 ft.–lbs. (34–38 Nm) torque.
Disconnect the electrical connector from the parking brake pedal sensor (Item 2) [A]. The connector is located behind the control panel.
Remove the parking brake assembly from the loader by moving the rubber floor mat and removing the tube clamp (Item 1) [C] and sliding the tube and wires out.
Reverse the removal procedure to install the parking brake assembly in the loader.
Disassembly and Assembly
Loosen and remove the mounting bolt (Item 1) [B] and nut from the spring mounting bracket (Item 2) [B].
Remove the brake pedal spring (Item 3) [B] from the tension spring mounting bracket (Item 2) [B] and from the brake pedal mounting bracket (Item 4) [B].
Remove the (2) mounting bolts, washers and nuts (Item
5) [B] from the brake pedal sensor.
Remove the harness mounting clamp (Item 1) [C] from the pedal mounting bracket (Item 4) [B].
Remove the sensor harness form the pedal mounting bracket.
Remove the pedal Mounting bolt (Item 6) [B], plastic spacers and bushing nut from the brake pedal.
Remove the pedal from the pedal mounting bracket.
Photo [C] shows the parking brake disassembled to identify the existing parts in the brake assembly.
…