Complete workshop & service manual with electrical wiring diagrams for Bobcat 1600 Loader. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This Bobcat 1600 Loader service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
6566667 (2-86) - 1600 Operator's Manual.pdf
6566906 (8-87) - 1600 Service Manual.pdf
6570468 (5-87) - 1600 Operation & Maintenance Manual.pdf
Removal And Installation
The tool listed will be needed to do the following procedure:
Raise the operator cab. (See Page 1–5 for the correct procedure.)
Remove the control center. (See Page 3–2 for the correct procedure.)
Remove the fuel tank on the side you are going to remove the gearcase. (See Page 5–13 for the correct procedure.)
Remove the nuts, on the outside of the loader, from the bracket which the fuel tank sets on [A].
Installation: Tighten the nuts to 220–245 ft.–lbs (300–330 Nm) torque.
Remove the bracket from the loader [B].
Remove the hydrostatic motor from the gearcase. (See Page 3–11 for the correct procedure.)
Remove the front cover and the brake assembly. (See Page 4–1 for the correct procedure.)
Remove the fluid from the chaincase [C].
NOTE: To remove the gearcase, you have to break the front chain.
Break the front chain. (See Page 4–21 for the correct procedure.)
Install the lift brackets on the gearcase.
Install a chain hoist on the lift brackets.