Complete workshop repair service manual with electrical wiring diagrams for Bobcat S205 Skid-Steer Loader. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Bobcat S205 Skid-Steer Loader service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

6902839 (12-06) - S205 Turbo, S205 Turbo High Flow Operation & Maintenance Manual.pdf
6902917 (7-09) - S205 Turbo, S205 Turbo High Flow Service Manual.pdf
6904136 (4-08) - S205 Skid-Steer Loader Operation & Maintenance Manual.pdf
6904138 (7-09) - S205 Skid-Steer Loader Service Manual.pdf
6986987 (3-08) - S205 Skid-Steer Loader Operation & Maintenance Manual.pdf
6987013 (11-10) - S205 Skid-Steer Loader Operation & Maintenance Manual.pdf
6987037 (7-09) - S205 Skid-Steer Loader Service Manual.pdf
6987050 (2-11) - S205 Skid-Steer Loader Service Manual.pdf
6987050 (6-10) - S205 Skid-Steer Loader Service Manual.pdf

EXCERPT:
CONTENTS
FOREWORD. . . . .. II
SAFETY INSTRUCTIONS . . . . . . V
FIRE PREVENTION . . . . . . VII
SERIAL NUMBER LOCATIONS . . . . .. IX
DELIVERY REPORT. . . . . . . X
LOADER IDENTIFICATION . . . . .XI
SAFETY & MAINTENANCE . . . . .. 10-01
HYDRAULIC SYSTEM . . . . . . 20-01
HYDROSTATIC SYSTEM . . . . .. . . 30-01
DRIVE SYSTEM . . . . . . . 40-01
MAINFRAME. . . . . . . . . . 50-01
ELECTRICAL SYSTEM & ANALYSIS. . . . . . 60-01
ENGINE SERVICE . . . . . 70-01
HEATING, VENTILATION, AIR CONDITIONING . . . . .80-01
SPECIFICATIONS. . . . . . . SPEC-01
…
Figure 20-61-20
Connect the starter bypass tool to the starter solenoid battery terminal and S terminal. Crank the engine for 15 seconds, then stop for at least 30 seconds. Again, crank the engine for 15 seconds. Remove the starter bypass tool [Figure 20-61-20].
Start the loader from the operators cab and run the engine at low idle for 1 - 2 minutes without operating the hydraulics.
After operating the engine at low idle, Remove the lift arm support device and fully raise and lower the loader lift arms several times or until air is purged from the system.
Avoid running over the relief valve setting at the end of cylinder stroke.
With the loader parked on a level surface and lift arms down, check and fill the hydraulic reservoir as required.
Check for hydraulic leaks.
…