Complete workshop & service manual with electrical wiring diagrams for Bobcat S330 Skid-Steer. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Bobcat S330 Skid-Steer service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

6904789 (4-08) - S330 Skid-Steer Loader Operation & Maintenance Manual.pdf
6904887 (3-09) - S330 Skid-Steer Loader Service Manual.pdf
6986681 (3-09) - S330 Skid-Steer Loader Service Manual.pdf
6986973 (11-10) - S330 Skid-Steer Loader Operation & Maintenance Manual.pdf
6986995 (4-08) - S330 Skid-Steer Loader Operation & Maintenance Manual.pdf
6987040 (5-11) - S330 Skid-Steer Loader Service Manual.pdf
6987040 (11-10) - S330 Skid-Steer Loader Service Manual.pdf

EXCERPT:
CONTENTS
FOREWORD. . . . . . . . II
SAFETY INSTRUCTIONS . . . . V
FIRE PREVENTION . . . . . . . . VII
SERIAL NUMBER LOCATION . . . . . . . . IX
DELIVERY REPORT. . . . . . . . . IX
BOBCAT LOADER IDENTIFICATION. . . . . . . . . . X
SAFETY & MAINTENANCE . . . . . . . 10-01
HYDRAULIC SYSTEM . . . . 20-01
HYDROSTATIC SYSTEM . . . . . . . . . 30-01
DRIVE SYSTEM . . . . . . . . . 40-01
MAINFRAME. . . . . 50-01
ELECTRICAL SYSTEM & ANALYSIS. . . . . . . 60-01
ENGINE SERVICE . . . . . . . 70-01
HEATING, VENTILATION, AIR CONDITIONING . . . . . 80-01
SPECIFICATIONS. . . . . SPEC-01
…
HYDRAULIC PUMP (SJC) (HIGH FLOW) (CONT’D)
Removal And Installation (Cont’d)
Figure 20-71-35
At the front side of the gear pump, disconnect and cap the three hoses (Item 1) from the inlet side of the hydraulic pump [Figure 20-71-35].
Figure 20-71-36
At the right side access hole, disconnect the electrical connector (Item 1) [Figure 20-71-36] from the high flow pump solenoid.
Figure 20-71-37
Remove the two mounting bolts (Item 1) [Figure 20-71-37] from the hydraulic pump.
Installation: Tighten the mounting bolts to 65 - 70 ft.-lb. (88 - 95 N•m) torque.
At the bottom side of the gear pump, remove the pump bolt (Item 2) [Figure 20-71-37] from pump support bracket.
Installation: Tighten the pump support bracket bolt to 175 - 190 ft.-lb. (237 - 257 N•m) torque.
Remove the pump support bracket (Item 2) [Figure 20-71-37] from the loader.
Remove the hydraulic pump from the hydrostatic pump.
Remove the O-ring from the hydrostatic pump.
Installation: Use a new O-ring when installing the hydraulic pump.
…