Complete workshop repair & service manual with electrical wiring diagrams for Bobcat T3571, T3571L Telescopic Handler. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Bobcat T3571, T3571L Telescopic Handler service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

4852150 (7-06) - T3571, T3571L Service Manual.pdf
6986765 (2-10) - T3571, T3571L Telescopic Handler Service Manual.pdf
6989559 (2-10) - T3571(L) Telescopic Handler Operation & Maintenance Manual.pdf

EXCERPT:
CONTENTS
SAFETY AND MAINTENANCE . . . 10-01
HYDRAULIC SYSTEM . . . 20-01
HYDROSTATIC SYSTEM . . . . . . . . 30-01
DRIVE SYSTEM . . . . . . . . 40-01
MAIN FRAME . . . 50-01
ELECTRICAL SYSTEM AND ANALYSIS . . . 60-01
ENGINE SERVICE . . . . . . 70-01
HEATING, VENTILATION, AIR CONDITIONING . . . . 80-01
SPECIFICATIONS . . . SPEC-01
ALPHABETICAL INDEX . . . . . .INDEX-01
…
HYDROSTATIC DRIVE MOTOR (CONT'D)
Assembly (Cont'd)
Figure 30-30-88
Install the synchronizing shaft and rollers (Item 1) [Figure 30-30-88] into the motor shaft races. When properly installed the synchronizing shaft should move freely in all directions.
NOTE: The motor shaft end of the synchronizing shaft is smaller than the cylinder end.
Figure 30-30-89
When installing the cylinder block, the races (Item 1) [Figure 30-30-89] in the cylinder block must be positioned so the synchronizing shaft rollers (Item 2) [Figure 30-30-88] and pistons (Item 3) [Figure 30-30-88] and their bores (Item 2) [Figure 30-30-89] are aligned.
Install the six pistons (Item 3) [Figure 30-30-88] into the cylinder bores, tilt the block so the synchronizing shaft rollers enter their races in the block and the support pin (Item 3) [Figure 30-30-89] enter the recess.
…