Complete workshop & service manual with electrical wiring diagrams for 2009 Ford Edge, 2009 Lincoln MKX. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This 2009 Ford Edge, 2009 Lincoln MKX. service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· K30 -- Ford Edge, Front Wheel Drive (FWD), ST
· K36 -- Ford Edge, FWD , SE
· K38 -- Ford Edge, FWD , SEL
· K39 -- Ford Edge, FWD , SEL Plus
· K40 -- Ford Edge, All-Wheel Drive (AWD), ST
· K46 -- Ford Edge, AWD , SE
· K48 -- Ford Edge, AWD , SEL
· K49 -- Ford Edge, AWD , SEL Plus
· U68 -- Lincoln MKX, FWD , Premium
· U88 -- Lincoln MKX, AWD , Premium

· C -- 3.5L, DOHC, EFI, V-6

EXCERPT:
2009 Edge/MKX
Workshop Manual
Quick Links
Introduction
Master DTC Chart
Specifications
Metrics
Torque Wrench Adapter Formulas
Acronyms
Alphabetical Index
Table of Contents
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting
…
All camshafts
NOTICE: The crankshaft must remain in the freewheeling position (crankshaft dowel pin at 9 o'clock) until after the camshafts are installed and the valve clearance is checked/adjusted. Do not turn the crankshaft until instructed to do so. Failure to follow this process will result in severe engine damage.
Rotate the crankshaft counterclockwise until the crankshaft dowel pin is in the 9 o'clock position.
1. LH camshafts
NOTICE: The camshafts must remain in the neutral position during installation or engine damage may occur.
NOTE: Coat the camshafts with clean engine oil prior to installation.
Position the camshafts onto the LH cylinder head in the neutral position as shown.
2. NOTICE: Cylinder head camshaft bearing caps are numbered to verify that they are assembled in their original positions. If not reassembled in their original positions, severe engine damage may occur.
Install the 8 camshaft caps and the 16 bolts.
· Tighten in the sequence shown to 10 Nm (89 lb-in).
…