Complete workshop & service manual with electrical wiring diagrams for Ford Escape, Escape Hybrid, Mercury Mariner, Mariner Hybrid 2011. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford Escape, Escape Hybrid, Mercury Mariner, Mariner Hybrid 2011 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· N2K - Mariner, Hybrid - Front Wheel Drive (FWD)
· N3K - Mariner, Hybrid - All-Wheel Drive (AWD)
· N8B - Mariner, Luxury - FWD
· N8H - Mariner, Premier - FWD
· N9B - Mariner, Luxury - AWD
· N9H - Mariner, Premier - AWD
· U0C - Escape, XLS - FWD
· U0D - Escape, XLT - FWD
· U0E - Escape, Limited - FWD
· U4K - Escape, Hybrid - FWD
· U5K - Escape, Hybrid - AWD
· U9C - Escape, XLS - AWD
· U9D - Escape, XLT - AWD
· U9E - Escape, Limited - AWD

· G - 3.0L Modular, 6-cylinder, electronic fuel injection, DOHC
· 3 - ATK-CYC, 2.5L, 4-valve port fuel injection, in-line 4 cylinder, gas/electric (Hybrid)
· 7 - 2.5L, 4-valve, in-line 4 cylinder

EXCERPT:
2011 Escape, Mariner, Escape Hybrid, Mariner Hybrid
Workshop Manual
Quick Links
Introduction
Master DTC Chart
Specifications
Metrics
Torque Wrench Adapter Formulas
Acronyms
Alphabetical Index
Table of Contents
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting
…
1. Remove the camshafts. For additional information, refer to Camshafts in this section.
2. NOTE: If the camshafts and valve tappets are to be reused, mark the location of the valve tappets to make sure they are assembled in their original positions.
NOTE: The number on the valve tappets only reflects the digits that follow the decimal. For example, a tappet with the number 0.650 has the thickness of 3.650 mm.
3. Remove and inspect the valve tappets. For additional information, refer to Section 303-00 .
To install, reverse the removal procedure.
· Coat the valve tappets with clean engine oil prior to installation.