Complete workshop & service manual with electrical wiring diagrams for Ford Expedition, Lincoln Navigator 2005. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This Ford Expedition, Lincoln Navigator 2005 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
· U13 Expedition, 4x2, XLS
· U14 Expedition, 4x4, XLS
· U15 Expedition, 4x2, XLT
· U16 Expedition, 4x4, XLT
· U17 Expedition, 4x2, Eddie Bauer
· U18 Expedition, 4x4, Eddie Bauer
· U19 Expedition, 4x2, Limited
· U20 Expedition, 4x4, Limited
· U27 Navigator, 4x2
· U28 Navigator, 4x4
· 5 5.4L, SOHC, EFI, 3V, V-8, gas
1 2 A B C D
E F G H I J
K L M N O P
Q R S T U V
Table of Contents
1: General Information
00: Service Information
06: Brake System
11: Steering System
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
02: Frame and Mounting
GROUP 03: Engine
SECTION 303-00: Engine System General Information
SECTION 303-01: Engine
SECTION 303-03: Engine Cooling
SECTION 303-04: Fuel Charging and Controls
SECTION 303-05: Accessory Drive
SECTION 303-06: Starting System
SECTION 303-07: Engine Ignition
SECTION 303-08: Engine Emission Control
SECTION 303-12: Intake Air Distribution and Filtering
SECTION 303-13: Evaporative Emissions
SECTION 303-14: Electronic Engine Controls
Removal and Installation
1. Disconnect the electrical connectors.
2. Remove the windshield washer reservoir screws.
NOTE: Windshield washer fluid should be collected in a container after the windshield washer hoses are disconnected.
3. Disconnect the windshield washer hoses.
4. Remove the windshield washer reservoir.
5. Remove the windshield washer pump if necessary.