Logo

Cart

Click title to display cart contents.
0 Items US$ 0.00

Ford Freestar, Mercury Monterey 2007 Factory Service & Shop Manual

Catalog: 

Make: 

Model: 

Price: US$ 19.99

Complete workshop & service manual with electrical wiring diagrams for Ford Freestar, Mercury Monterey 2007. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford Freestar, Mercury Monterey 2007 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· A50 — Base — Freestar
· A51 — SE — Freestar
· A52 — SEL — Freestar
· A53 — GLE — Freestar
· A54 — Van — Freestar
· A55 — SE (Canada) — Freestar
· A56 — GLE (Canada) — Freestar
· A57 — SES — Freestar
· A57 — Sport (Canada) — Freestar
· A58 — Limited — Freestar
· A22 — Luxury — Monterey

· 2 — 4.2L, OHV, EFI, 6 cylinder
· 6 — 3.9L, OHV, EFI, 6 cylinder

EXCERPT:
2007 Freestar/Monterey
Workshop Manual
Alphabetical Index
A B C D E F
G H I J K L
M N O P Q R
S T U V W
Table of Contents
Introduction
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting

1. Disconnect the battery ground cable. For additional information, refer to Section 414-01.
2. Remove the air cleaner outlet pipe. For additional information, refer to Section 303-12.
3. Remove the front and rear roll restrictor bolts and the roll restrictor.
· To install, tighten to 63 Nm (46 lb-ft).
4. Remove the upper and lower roll restrictor bolts and the roll restrictor bracket.
· To install, tighten to 90 Nm (66 lb-ft).
5. Disconnect the knock sensor (KS) electrical connector.
6. Remove the nut and the KS.
· To install, tighten to 20 Nm (15 lb-ft).
7. To install, reverse the removal procedure.