Complete workshop repair service manual with electrical wiring diagrams for Ford Ranger 2001. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford Ranger 2001 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· R08 — 4x2, Regular cab (electric)
· R10 — 4x2, Regular cab
· R11 — 4x4, Regular cab
· R14 — 4x2, SuperCab
· R15 — 4x4, SuperCab

· C — 2.5L, SOHC, four cylinder, gas
· D — 2.3L, EFI, four cylinder, gas
· U — 3.0L, V6, gas
· E — 4.0L, SOHC, V6, gas
· 1 — 336V-75 HP electric (nickel metal hydride)
· 7 — 336V-75 HP electric (lead acid)

EXCERPT:
2001 Ranger
Workshop Manual
Alphabetical Index
A B C D E F
G H I J K L
M N O P R S
T U V W
Table of Contents
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting
…
Exhaust Gas Recirculation (EGR) Valve —2.3L
Removal and Installation
1. Drain the cooling system. For additional information, refer to Section 303-03 .
2. Disconnect the battery ground cable. For additional information, refer to Section 414-01 .
3. Disconnect the exhaust gas recirculation (EGR) valve electrical connector.
4. Remove the rear driveshaft. For additional information, refer to Section 205-01.
5. Remove the bolts retaining the catalytic converter to the muffler. Discard the exhaust converter outlet gasket.
NOTE: Manual transmission shown, automatic transmission similar.
6. Support the transmission with a suitable transmission jack.
7. Remove the six bolts (three on each side) retaining the crossmember to the frame.
8. Remove the retaining nuts and the crossmember.
…