Complete workshop & service manual with electrical wiring diagrams for Ford Ranger 2003. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford Ranger 2003 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· R08 — 4x2, Regular cab (electric)
· R10 — 4x2, Regular cab
· R11 — 4x4, Regular cab
· R14 — 4x2, SuperCab (two-door)
· R15 — 4x4, SuperCab (two-door)
· R44 — 4x2, SuperCab (four-door)
· R45 — 4x4, SuperCab (four-door)

· 7 — 336V-75 HP electric (lead acid)
· D — 2.3L, EFI, four cylinder, gas
· E — 4.0L, EFI, SOHC, V6, gas
· U — 3.0L, EFI, OHV, V6, gas
· V — 3.0L, EFI, OHV, V6, flex-fuel

EXCERPT:
2003 Ranger
Workshop Manual
Alphabetical Index
A B C D E F
G H I J K L
M N O P R S
T U V W
Table of Contents
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting
…
Spark Plug Wire
Material
Item Specification
Silicone Dielectric Compound
D7AZ-19A331-A or equivalent ESE-M1C171-A
Removal and Installation
CAUTION: Do not pull on the spark plug wire as it may separate from the spark plug wire connector inside the spark plug wire boot.
NOTE: Wipe the spark plug wire sets with a clean, damp cloth before inspecting them. Without removing the spark plug wire sets from the spark plugs or ignition coils, inspect them for visible damage such as cuts, pinches, or cracked or torn boots.
1. Remove the spark plug wire by slightly twisting while pulling upwards.
2. Remove the spark plug wire by slightly twisting while pulling upwards.
3. Disconnect the spark plug wire if routed through another spark plug wire.
To install, reverse the removal procedure.
· Apply silicone dielectric compound to the locations shown
…