Complete workshop & service manual with electrical wiring diagrams for Ford Ranger 2005. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford Ranger 2005 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· R10 — 4x2, Regular cab
· R11 — 4x4, Regular cab
· R14 — 4x2, SuperCab (two-door)
· R15 — 4x4, SuperCab (two-door)
· R44 — 4x2, SuperCab (four-door)
· R45 — 4x4, SuperCab (four-door)

· D — 2.3L, EFI, four cylinder, gas
· E — 4.0L, EFI, SOHC, V6, gas
· U — 3.0L, EFI, OHV, V6, gas

EXCERPT:
2005 Ranger
Workshop Manual
Alphabetical Index
A B C D E F
G H I J K L
M N O P R S
T U V W
Table of Contents
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting
…
Brake Caliper
Inspect brake calipers for the following:
· Brake fluid leaks. Refer to Brake System Hydraulic Leak Check in this section.
· Boots and seals for tears or cracks.
· Caliper piston for binding and corrosion.
· Guide pins for correct operation. Refer to Brake Caliper Guide Pins in this section.
Brake Caliper Guide Pins
CAUTION: Do not use power tools for caliper guide pin bore cleaning.
The guide pins should slide with a reasonable amount of hand force. If the brake pads show taper wear or the guide pins are difficult to move, then carry out the following steps.
NOTE: If a guide pin kit is not available, install a new caliper assembly.
· Disassemble the guide pins. For additional information, refer to Section 206-03 .
· Use a wire brush, rolled up sandpaper or emery cloth to remove all corrosion and foreign material from the caliper guide pin bores. Clean remaining debris from bores with brake parts cleaner and compressed air.
· Install new brake pads if the lining is not within specifications. Refer to Section 206-03.
Assemble the caliper guide pins using new caliper seals, boots and guide pins. Use an ample amount of grease to lubricate the bores and guide pins.
…