Complete workshop & service manual with electrical wiring diagrams for Ford Ranger 2007. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford Ranger 2007 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· R10 — Rear wheel drive (RWD), Regular cab
· R11 — Four wheel drive (4WD), Regular cab
· R14 — RWD, SuperCab (2-door)
· R15 — 4WD, SuperCab (2-door)
· R44 — RWD, SuperCab (4-door)
· R45 — 4WD, SuperCab (4-door)

· D — 2.3L, EFI, 4-cylinder, gas
· E — 4.0L, EFI, SOHC, V6, gas
· U — 3.0L, EFI, OHV, V6, gas

EXCERPT:
2007 Ranger
Workshop Manual
Alphabetical Index
A B C D E F
G H I J K L
M N O P Q R
S T U V W
Table of Contents
Introduction
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting
…
Transmission
Material
Item Specification
MERCON® Multi-Purpose Automatic
Transmission Fluid
XT-2-QDX (US); XT-2-LM12 (Canada)
MERCON®
NOTE: Before securing the engine to the transmission, connect the hydraulic line to the clutch slave cylinder.
NOTE: Install the transfer case with a new gasket. Tighten the bolts that retain the transfer case to the extension housing in a clockwise direction beginning with the upper LH bolt.
NOTE: Install the front driveshaft with new bolts and washers and the rear driveshaft with new bolts.
NOTE: Align the index marks when installing the front and rear driveshafts.
NOTE: Check and, if necessary, fill the transmission with the specified type and quantity of fluid.
To install, reverse the removal procedure.
…