Click title to display cart contents.
0 Items $0.00

Ford Ranger 2010 Factory Service & Shop Manual




US Dollar: $19.99

Complete workshop & service manual with electrical wiring diagrams for Ford Ranger 2010. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford Ranger 2010 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· R1A - Rear Wheel Drive (RWD), regular cab
· R1E - RWD , SuperCab (2-door)
· R1F - Four-Wheel Drive (4WD), SuperCab (2-door)
· R4E - RWD , SuperCab (4-door)
· R4F - 4WD , SuperCab (4-door)

· D - 2.3L, electronic fuel injection, 4-cylinder, gas
· E - 4.0L, electronic fuel injection, SOHC, V6, gas

2010 Ranger
Workshop Manual
Quick Links
Master DTC Chart
Torque Wrench Adapter Formulas
Alphabetical Index
Table of Contents
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting

1. Position the Drive Pinion Bearing Cup Installer and the inner and outer drive pinion bearing cups in their respective bores.
1. After placing the inner and outer drive pinion bearing cups in their bores, place the Drive Pinion Bearing Cup Installer (inner) on the inner drive pinion bearing cup.
2. Place the Drive Pinion Bearing Cup Installer (outer) on the outer drive pinion bearing cup.
3. Install the Drive Pinion Bearing Cup Installer.
2. Tighten the Drive Pinion Bearing Cup Installer to seat the drive pinion bearing cups into their bores.
NOTE: If a feeler gauge can be inserted between a drive pinion bearing cup and the bottom of its bore at any point around the drive pinion bearing cup, the drive pinion bearing cup is not correctly seated.
Make sure the drive pinion bearing cups are correctly seated in their bores.

Additional 10% off on US$30+ order paid with Credit Card: 10POFF.

To pay in your local currency (EURO, GBP, AUD, CAD, HKD, JPY, etc.), please contact us.