Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Chevrolet Traverse 2008-2016. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Chevrolet Traverse 2008-2016 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2014 ENGINE Engine Mechanical - 3.6L (LLT) - Repair Instructions - On Vehicle - Acadia, Enclave And Traverse
Installation Procedure
1. If the intake manifold is being replaced, assemble the intake manifold. Refer to Intake Manifold Assemble.
2. Install a NEW intake manifold gasket.
3. Install the intake manifold.
4. Install the intake manifold bolts and tighten to 25 N.m (18 lb ft).
5. Position the engine wiring harness in place.
6. Install the engine wiring harness retaining clips (1) to the intake manifold.
7. Install the engine wiring harness retaining clip (1) to the side of the intake manifold.
8. Install the fuel pipe shield. Refer to Fuel Pipe Shield Replacement .
9. Connect the electrical connector (2) to the throttle body.
10. Install the electrical connector retainer (1).
11. Connect the purge line (2) to the purge solenoid valve.
12. Connect the purge solenoid valve electrical connector (1).
13. Install the rear positive crankcase ventilation hose. Refer to Positive Crankcase Ventilation Tube
Replacement - Rear.
14. Connect the brake booster vacuum hose to the intake manifold.
15. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
16. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
OIL LEVEL INDICATOR TUBE REPLACEMENT
...