Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2000–2006 & 2010–2014 Honda Insight. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for 2000–2006 & 2010–2014 Honda Insight is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2012 SUSPENSION Rear Suspension - Insight
DAMPER REPLACEMENT
EXPLODED VIEW
Fig. 10: Exploded View Of Damper With Torque Specifications
REMOVAL
1. Raise and support the vehicle (see LIFT AND SUPPORT POINTS ).
2. Remove the rear wheels.
3. Remove the wheel speed sensor clip (A) and the wire guide rubber (B) from both sides of the axle beam.
Fig. 11: Identifying Wheel Speed Sensor Clip And Wire Guide Rubber
4. Position a floor jack under lower spring seat (A) on both sides of the axle beam (B). Raise the floor jack until the suspension begins to compress.
Fig. 12: Identifying Floor Jack Under Lower Spring Seat, Axle Beam, Damper Mounting Bolt And Damper
5. Remove the damper mounting bolt (C) that connects the axle beam and the damper (D) from both sides.
6. Remove the access panel (A) on the cargo area side trim.
Left side:
Fig. 13: Identifying Access Panel On Cargo Area Side Trim - Left Side
Right side:
Fig. 14: Identifying Access Panel On Cargo Area Side Trim - Right Side
7. Remove the self-locking nut (A) while holding the damper shaft (B) with a hex wrench (C).
Fig. 15: Removing Self-Locking Nut While Holding Damper Shaft With Hex Wrench
8. Remove the damper mounting washer (D) and the damper rubber mount (E) from the top of the damper.
9. Compress the damper assembly (A) by hand, and remove it from the vehicle.
NOTE: Be careful not to damage the body.
Fig. 16: Identifying Damper Assembly And Damper Rubber Mount
10. Remove the damper rubber mount (B).
INSPECTION
1. Install the flange nut on the damper shaft end, and set the socket wrench and T-handle on the nut.
2. Compress the damper unit by hand, and check for smooth operation through a full stroke, both compression and extension. The damper should extend smoothly and constantly when compression is released. If it does not, the gas is leaking and the damper should be replaced.
Fig. 17: Compressing Damper Unit By Hand
3. Check for oil leaks, abnormal noises, and binding during these tests.
INSTALLATION
1. Install the damper rubber mount (A) onto the damper unit (B). Position the damper assembly between the body and the axle beam.
...