Complete digital workshop repair manual contains service, maintenance, and troubleshooting information for the Scion xD 2007-2014. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Scion xD 2007-2014 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

MAKE: Scion
MODEL: xD
YEAR: 2007 2008 2009 2010 2011 2012 2013 2014

EXCERPT:
MANUAL TRANSAXLE OIL
ON-VEHICLE INSPECTION

1. INSPECT TRANSAXLE OIL
a. Stop the vehicle in a level place.
b. Remove the filler plug and the gasket.
c. Check that the oil surface is within 5 mm (0.20 in.) of the bottom of the filler plug opening.
NOTE: Excessively large or small amounts of oil may cause problems. After replacing the oil, drive the vehicle and check the oil level again.
Fig. 1: Identifying Oil Surface Level
d. Check for oil leakage when the oil level is low.
e. Install the filler plug and a new gasket. Torque: 39 N*m (400 kgf*cm, 29 ft.*lbf)

DIFFERENTIAL OIL SEAL
COMPONENTS
Fig. 2: Identifying Differential Oil Seal Components With Torque Specifications (1 Of 2)
Fig. 3: Identifying Differential Oil Seal Components (2 Of 2)
REMOVAL
1. DRAIN TRANSAXLE OIL
a. Remove the filler plug and the gasket.
b. Remove the drain plug and gasket, and then drain the manual transaxle oil.
c. Install a new gasket and the drain plug. Torque: 39 N*m (400 kgf*cm, 29 ft.*lbf)
2. REMOVE FRONT WHEELS
3. REMOVE FRONT AXLE HUB NUT LH (See REMOVAL )
4. REMOVE FRONT AXLE HUB NUT RH
HINT: The removal procedure for the RH side is the same as that for the LH side.
5. SEPARATE FRONT SPEED SENSOR LH (See REMOVAL )
6. SEPARATE FRONT SPEED SENSOR RH
HINT:The separation procedure for the RH side is the same as that for the LH side.
7. SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH (See REMOVAL )
8. SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH
HINT: The separation procedure for the RH side is the same as that for the LH side.
9. SEPARATE TIE ROD END SUB-ASSEMBLY LH (See REMOVAL )
10. SEPARATE TIE ROD END SUB-ASSEMBLY RH
HINT: The separation procedure for the RH side is the same as that for the LH side.
11. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH (See REMOVAL )
12. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
HINT: The separation procedure for the RH side is the same as that for the LH side.
13. SEPARATE FRONT AXLE ASSEMBLY LH (See REMOVAL )
14. SEPARATE FRONT AXLE ASSEMBLY RH
HINT: The separation procedure for the RH side is the same as that for the LH side.
15. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH (See DISASSEMBLY )
16. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH (See DISASSEMBLY )
17. REMOVE TRANSAXLE CASE OIL SEAL
a. Using SST, remove the oil seal. SST 09308-00010
Fig. 4: Removing Oil Seal With SST
18. REMOVE TRANSMISSION CASE OIL SEAL
a. Using SST, remove the oil seal.
...