Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Volvo C70 1997-2013. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Volvo C70 1997-2013 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2013 Volvo C70 T-5 - ENGINE Engine - Removal, Replacement And Installation
ACCESSORY DRIVE BELT AND TENSIONER (B5254T3 AND B5254T7)
ACCESSORY DRIVE BELT
REMOVAL
Remove right front wheel. See WHEELS
Fig. 1: Removing Fender Liner
Fig. 2: Identifying Splash Panel Screws
Fig. 3: Loosening Belt Tension
Fig. 4: Removing Belt
Fig. 5: Loosening Belt Tension
Fig. 6: Removing Belt
INSTALLATION
To install, reverse the removal procedure.
ACCESSORY DRIVE BELT TENSIONER
REMOVAL
Remove the auxiliaries belt. See ACCESSORY DRIVE BELT
Fig. 7: Removing/Installing Tensioner Bolt
Fig. 8: Removing Tensioner Bolt
INSTALLATION
Fig. 9: Removing Tensioner Bolt
Torque: Belt tensioner accessory drive belt
42 Nm
Fig. 10: Removing/Installing Tensioner Bolt
NOTE: Only tighten the bolt finger tight at this stage.
Fig. 11: Installing Tensioner Bolt
1. Torque: Belt tensioner accessory drive belt
42 Nm
Fig. 12: Identifying Gap at Tensioner
Install the auxiliaries belt. See ACCESSORY DRIVE BELT
CRANKSHAFT FRONT/REAR SEALS AND CARRIER PLATE (B5254T3 AND
B5254T7)
CARRIER PLATE
CARRIER PLATE
Special tools:
see 9995112
see 9995678
PREPARATORY WORK
REMOVING THE TRANSMISSION
Remove the transmission according to TRANSMISSION, REMOVING .
REMOVAL
REMOVING THE CARRIER PLATE
NOTE: As the graphics in this service information are used for different model years and/or models, some variation may occur. However, the essential information is
always correct.
Remove the engine speed (RPM) sensor together with the bracket. Place the engine speed (RPM) sensor to one side.
Fig. 13: Blocking Carrier Plate Using Gear Sector 999 5112
Block the carrier plate using gear sector see 9995112 .
Remove:
all screws
the carrier plate
gear sector see 9995112 .
Fig. 14: Check Crankshaft Seal For Leakage
Check the crankshaft seal for leakage.
To replace the crankshaft seal, refer to CRANKSHAFT SEAL, REAR.
...